The Steps in Cleaning and Staining a Deck

The Steps in Cleaning and Staining a Deck

It’s deck sprucing-up time, and I thought I would share some tips on staining from Debbie Zimmer at the Paint Quality Institute. Assuming that your deck doesn’t need repairs, the first step is to remove any loose paint or stain that may be present. This is done in one of two ways: by scraping and sanding, or by treating the surface with a commercial deck conditioner, followed by careful power washing with plain water.

The prep work can be even easier if the deck has no loose paint or stain. Clean the surface with a commercial product, or, to save money, make your own by mixing a cup of household bleach and a splash of soap with a gallon of warm water. After scrubbing the surface clean, rinse it very thoroughly using a garden hose.

If, after cleaning, you still have areas with stubborn mildew, apply a solution of three parts water to one part bleach, allow the solution to sit on the affected surface for 20 minutes, then scrub off the mildew and rinse the surface clean, Zimmer says.

Once the surface preparation is complete, pick your stain. There are solvent-based and water-based formulations, but water-based stains offer significant advantages: They have better resistance to weathering, dry more quickly, are relatively odor-free, and clean up with plain soap and water.

Another consideration: whether to use a clear deck finish or a pigmented stain. This decision may be dictated by the condition and color of the wood on your deck, but durability is another important concern.

Clear-wood finishes provide only limited protection from the sun’s UV rays, so they need to be reapplied every 12 months or so; pigmented stains afford more UV protection, so they last longer.

There are two types of pigmented stains. “Semitransparent” coatings help protect the wood without hiding its grain or texture, while “solid-color” stains show texture but not the grain.

The former need to be reapplied every 12 to 18 months, but solid-color stains can last three to five years, so if you want to stretch out your application cycle, go with a solid-color finish.

Consider the stress a deck endures, such as standing water, snow and ice, foot traffic, abrasion from patio furniture, and direct sunlight.

Zimmer says that top-quality 100 percent acrylic latex stains—either semitransparent or solid-color—are perhaps the best option when restoring a deck.

“They’re tough and durable, and many of these stains contain extra ingredients to help prevent mildew,” she says.
Stains can be applied with spray equipment, a long-handled roller, or by brush.

“However, spray or roller application should be followed by back brushing,” she says. (That means going back in and brushing the stain while it’s still wet so that it better penetrates the wood.)

By Al Heavens, RISMedia

Contact Information

Photo of Laurel Sweeney Real Estate
Laurel Sweeney
Berkshire Hathaway HomeServices Nutshell Realty
1209 State Route 213, PO Box 452
High Falls NY 12440
Office: 845-687-2200
Toll Free 877-468-5783
Fax: 845-687-4162

© 2016 BHH Affiliates, LLC. An independently owned and operated franchisee of BHH Affiliates, LLC. Berkshire Hathaway HomeServices and the Berkshire Hathaway HomeServices symbol are registered service marks of HomeServices of America, Inc.®.  Equal Housing Opportunity.